1. Degrease the MMS ECU using primer; apply primer only
to indicated areas where tape is attached on both sides.
2. Apply Double-sided tape on the MMS ECU.
3. Flip over the MMS ECU and apply Foam tape.
4.
Detach 2 Vehicle harness clamps from the Vehicle bracket.
5. Plug in MMS harness 2P connector to Vehicle harness 2P
connector.
6. Install the MMS harness Ground terminal to the Vehicle
Ground terminal bolt.
Bolt tightening torque: 8.8 - 12.7 N•m (6.4 - 9.3 ft•lbf)
7. Place the MMS ECU in between the Vehicle bracket and
Vehicle harness attaching the double-sided tape on the
Vehicle bracket.
8. Create 2 extra large wire ties by using 2 sets of 2 wire
ties, where 1 set consists of 2 wire ties (white) connected
together to create 1 extra large wire tie.
9. Secure the Vehicle harness and MMS ECU together to the
Vehicle bracket using the 2 extra large wire ties (white).
8. MAZDA MOBILE START INSTALLATION
Double-sided
Adhesive tape
MMS ECU
MMS ECU
• Use 3M Promoter-4298 for primer.
•
When degreasing using primer, only apply primer to indicated
area to prevent other parts from becoming discolored.
•
After degreasing using primer, let it dry for 1 min. or more.
•
Clean attachment surface using isopropyl alcohol and
cleaning towel.
Ground
location
SIDE VIEW
FRONT VIEW
Urethane
foam tape
Vehicle harness
2P connector
MMS 2P
connector
Clamps
Caution
Caution
13
