b) Attach wire tap connector to
Yellow / Green-
striped wire
approximately ½” up from
connector.
(Fig. 5-7)
c) Using pliers, close 2 sides of wire-tap onto wire.
(Fig. 5-7)
5. Connect EC power harness to B+ Constant.
a) Insert male spade terminal of
Solid Black
wire
into opening of wire tap on the
Yellow / Green-
striped
wire
.
(Fig. 5-8)
1. Separate EC harness power and ground wires.
a) Pull power and ground wires apart (approx. 8
inches).
(Fig. 5-9)
2. Attach wire tap connector to +12V ignition in lower
14-pin A-pillar connector.
a) Locate
14-pin
connector
(C214
) on driver side
A-pillar.
(Fig. 5-10)
Yellow / Green
Pin #5
Lower
Connector
Upper
Connector
Fig. 5-7
Fig. 5-8
Ensure male spade connector is fully inserted into wire tap.
Check to see that the spade connector did not miss the slot.
Check to see that it is not visible on either side of the female
connector.
CAUTION
!
Fig. 5-9
5b
Connect B+ Constant and Ignition
2009 Models
Fig. 5-10
Connector C214
b) Using fiber stick, remove 14-pin connector from
A-pillar
. (Fig. 5-10)
Page 8 of 17
9/1/2010
