Tie
Wraps
CAUTION
!
Fig. 4-5
4. Route EC harness down A-pillar and secure with (3)
small tie wraps as shown. (Fig. 4-5)
CAUTION
!
Verify mirror harness path is clear of air bag (if equipped).
CAUTION
!
Do not secure to plastic drain tube if present.
MY 2010
use section:
5c
5b
MY 2009
use section:
MY 2008
use section:
5a
The following installation steps in section 5 are model year specific.
Ensure that the model year of the vehicle and the installation steps used
match as noted below:
NOTE
!
2008 Models
Fig. 5-1
1. Separate EC harness power and ground wires.
5a
Connect B+ Constant and Ignition
a) Pull power and ground wires apart (approx. 8
inches).
(Fig. 5-1)
Connector C214
Fig. 5-2
2. Attach wire tap connector to +12V ignition in lower
10-pin A-pillar connector.
a) Locate
10-pin
connector
(C214
) on driver side
A-pillar.
(Fig. 5-2)
b) Using fiber stick, remove 10-pin connector from
A-pillar
. (Fig. 5-2)
Page 6 of 17
9/1/2010
