Page 13 of 17
9/1/2010
1. Bundle excess power harness and secure.
a) Bundle any excess power harness wires.
b) Secure bundled harness wires to factory wire
bundle in A-pillar with (3) small tie wraps as
shown.
(Fig. 7-1)
1. Reconnect negative battery cable.
2. Turn the ignition switch ON.
3. With the vehicle in a fairly well-lit area, perform the
following
:
a) To make sure the auto-dimming feature is on,
verify that the green LED to the left of the
center switch is on. If it is not on, push the
switch to turn the green LED on.
b) Cover the forward looking photocell on the
back of mirror with a dark cloth or towel.
(Fig. 8-1)
In a few seconds, the mirror will begin to darken.
c) Remove the cover from the forward looking
photo cell and the mirror will begin to clear.
d) Verify that either a direction, such as NE, or
“C” is displayed in the display window. If not,
ensure the feature is turned ON by pressing the
button.
4. Turn the ignition key to the OFF position.
5. Push each HomeLink® button, one at a time, and
verify that LED indicator to the left of the center
switch illuminates with a red LED. (Fig. 8-2)
6. Testing is now complete.
7
Secure Remaining Harness Wires.
Tie Wrap
8
Testing
CAUTION
!
Do not secure to plastic drain tube if present.
Fig. 7-1
CAUTION
!
NOTE
!
Time to darken will vary with ambient light level.
Red LED
HomeLink Buttons
Fig. 8-2
NOTE
!
If compass remains on refer to page 14 and recheck installation.
