INSTALLATION PRECAUTIONS / NOTES:
•
Do not use excessive force when removing OE mirror from windshield.
•
Do not place wire harness against objects with sharp edges that may cause electrical
shorting.
•
On vehicles equipped with “A” pillar air bag, verify mirror harness path remains clear of
air bag. Harness should follow, and be tied to existing OEM wiring with tie wraps.
•
Verify that power harness path will not interfere with brake, clutch, emergency brake or
air bag operation. Use tie wraps to hold the wiring away from critical locations.
1
Perform the following pre-installation steps:
1. Place kit components on a clean, padded
surface and inspect for damage or defects.
2. Record customer’s programmed radio stations
(if applicable).
1. Disconnect negative battery terminal.
a) Using 8 mm socket, remove negative battery
terminal.
(Fig. 1-1)
2. Remove driver-side door seal.
a) Pull back past top of A-pillar trim.
(Fig. 1-2)
3. Partially remove A-pillar trim.
a) Using fiber stick, pull the top portion of the A-
pillar trim out toward the passenger-side
approximately ½” to detach (2) clips.
(Fig. 1-3)
Fig. 1-1
Negative
Battery
Terminal
P
1
Preparation
Fig. 1-2
Fig. 1-3
Page 2 of 17
9/1/2010
