MaxTronic Orion 410SR, User Manual

Page: 23 / 104

Maxtronic Orion 410SR User Guide
9
Hardware Installation
10. Now you could push back the front panel door
and locked for next setp.
Do not install the HDD(s) into the Orion 410SR NAS Sys-
tem while it’s powered off under any conditions.
The following are exceptions:
1. The HDD(s) have been initialized by the same Orion 410SR
and have been performing daily routine tasks.
2. Performing “Disk Roaming” procedure to reduce system
down time.
To perform “Disk Roaming“:
a. Power off the old NAS system.
b. Execute Factory Default on the new NAS system and
then power it off.
c. Remove the HDD(s) from the old NAS system.
d. Insert the HDD(s) into the new NAS system. Please be
sure the model and firmware of the new system are the
same as the old one.
e. Power on the new NAS system and Disk roaming is com-
plete.
Hot plugging previously initialized HDD(S) will overwrite existing
user configurations, RAID settings, and any data in the drive.