Installation manual
Liftgate GPC 22 X-1, Series 11
Document no.: S 20 912 436
41
Version 2021
GPC 22 X-1
THE MAXIMUM CAPACITY OF
THIS LIFT IS
2200 POUNDS
IMPORTANT
All liftgate warning, capacity, and caution decals
should be affixed to the truck body in plain view
of the operator near the main lift gate Control Station.
IMPORTANT
The main liftgate Control Station is normally
mounted on right rear corner of the truck body.
WARNING
READ CAREFULLY
Improper operation of this Lift can result in serious personal injury. Do
not operate unless you have been properly instructed and have read, and
are familiar with the operating instructions. If you do not have a copy of
the instructions, please obtain them from your employer, distributor, or
lessor, before you attempt to operate Lift
Be certain that the vehicle is properly and securely braked beforeusing
the Lift
Always inspect this Lift for maintenance or damage before using it. If
there are signs of improper maintenance, damage to vital parts, or
slippery Platform surface, do not use the Lift until these problems have
been corrected
Do not overload the Lift. The load limit is based on evenly distributed
cargo over the entire Platform surface. If you are using a pallet jack, be
sure it can be maneuvered safely. Do not operate a forklift on the
Platform or travel with the platform in an open position at any time.
Load should be placed in a stable position close to the edge of the
Platform nearest the truck. The heaviest portion of the load should never
be placed beyond the center of the Platform away from the truck.
Never allow yourself, a helper, or bystander to stand in a position
where a falling load could land on either of you. Also do not allow any
part of yours or your helper body to be placed under, within, or around
any portion of the moving liftgate, or it`s mechanisms, or in a position
that would trap them between the platform and the ground or truck when
the liftgate is operated.
If a helper is riding the Platform with you, make sure you are both
doing so safely and that you are not in danger of coming in contact with
any moving or potentially moving obstacles. USE GOOD COMMON
SENSE. If load appears to be unsafe, do not lift or lower it.
MAXON LIFT CORP.
PART NO.
264081
STAND CLEAR
WHEN OPERATING
50092
WARNING
TILT THE PLATFORM TO
LEVEL POSITION PRIOR
TO RAISING
Summary of Contents for GPC 22 X1
Page 2: ......
