6
Read and understand this entire manual before installation. Check with the local building department prior to installing this gate
operator to comply with local building code requirements. The gate must be installed in a location so that enough clearance is
supplied between the gate and adjacent structures when opening and closing to reduce the risk of entrapment. Swinging gates
should not open into public access areas.
The gate must be properly installed and work freely in both directions prior to installation of the gate operator.
POWER
IN
POWER/SOLAR
IN
BA
TTER
Y
IN
www
.max.us.com
Made in USA
BA
TTER
Y
P
ACK
TO MOTOR
CONTROLLER
AC
ON
POWER
OFF
MAX PS-24
POWER SUPPLY
FUSE
7 AMP
IN
Made in USA
Power
INPUTS
MC-100
JOG
RIGHT
JOG
LEFT
UL
Entrap
Matrix
On Line
ERD
Sensitivity
Photo
Cell
Limit SW
On Line
Edge 2
Edge 1
Edge 1
Edge 2
Photo Cell
GND
Jog R
T
Jog L
T
MOTOR OVERLOAD
Motor Controller
ERD
Min
Max
POWER
IN
POWER/SOLAR
IN
BA
TTER
Y
IN
www
.max.us.com
Made in USA
BA
TTER
Y
PA
C
K
TO MOTOR
CONTROLLER
AC
ON
POWER
OFF
MAX PS-24
POWER SUPPLY
FUSE
7 AMP
IN
Made in USA
Power
INPUTS
MC-100
JOG
RIGHT
JOG
LEFT
UL
Entrap
Matrix
On Line
ERD
Sensitivity
Photo
Cell
Limit SW
On Line
Edge 2
Edge 1
Edge 1
Edge 2
Photo Cell
GND
Jog R
T
Jog L
T
MOTOR OVERLOAD
Motor Controller
ERD
Min
Max
Hinge Pivot Point
Illustrations not to scale
Gate Bracket Pivot Point
Arm
Pivot
Point
Longer
than “E”
Locked Position
Long Arm
Short Arm
Shorter
than “D”
15” Min
Operator
Pivot
Point
Concrete Pad
24” x 24”
DO NOT
allow arm to touch
hood in gate’s
OPEN
position.
TOO MUCH STRESS
is put on
the arm in this position during
gate operation.
Open Position
Closed Position
Outside Property
Inside Property
2” Min
2” Gate Frame
installation
Gate Operator position
A
Should be
at least
1/4 the gate length.
B
15” minimum for open gate clearance (2” thick gate).
C
Distance “A” minus 17 inches (A - 17 = C).
D
&
E
Arm should be 90° from gate when
OPEN
and in the straight “locked” position when
CLOSED
.
Measurement Guidelines
A
B
C
E
D
Hood
Preferred arm position is 90°
from open gate. See page 10
for arm position options and
connection to gate.
