11.01
Storage - Decommissioning
and dismantling
TI008G0001
Storage
The compressor is protected against corrosion and deterioration for the shipment period and for a rela-
tively short period of storage (3 months).
For longer periods please contact the manufacturer considering it can be maximum time 24 months.
In any case it is suitable to keep the machine in a dry place, protected against atmospheric agents.
In wet climates, to protect the electrical and mechanic components the machine should be kept in a
heated room or closed in a barrier- bag with heaters or light bulbs.
Specifically for the motor, please refer to what mentioned about the winding insulation.
Decommissioning
Decommissioning the machine does not involve any special precautions, only collection of the oil contained
in the machine and components of the lubrication system, like the oil filter and the oil-air separators.
WARNING !!!
Both these elements and the oil should be collected and dumped in compliance with
the current regulations on the environment in order to avoid any pollution and danger
of fire.
Dismantling
When the machine has reached the end of its technical and operating life, it can be demolished, i.e.
decommissioned and put in such a condition so as not to be used any longer for the purposes it was
designed and built, with the possible recycling of raw materials.
NOTE
Ing. ENEA MATTEI S.p.A.
will not take any responsibility for damage to people or objects that may de-
rive from the recycling of individual components of the machine, for operation or assembling situations
different that the original ones.
Ing. ENEA MATTEI S.p.A.
refuses any implicit or explicit acknowledgement of suitability to specific
purposes of the machine components re-used after the final dismantling in view of its demolition.
WARNING
The deactivation and dismantling of the machine should be carried out only by duly trained and equipped
staff.
Act as follows to deactivate the machine permanently:
❍
Drain the oil from the receiver.
❍
Disconnect the machine from the electrical and pneumatic supply systems.
❍
Lift the machine with suitable lifting means.
❍
Disassemble the machine main components.
❍
Block all the machine moving parts.
❍
Take all the machine components in supervised dumps.
Residual risks after deactivation
After deactivating the machine, there are no residual risk if all moving parts have been duly blocked.
!
098
