Matsusada DOEF Series, Instruction Manual

Page: 96 / 124

6 Master/Slave Option
88
DOEF series
Matsusada Precision
3. Settings of the slave units
For slave units, the settings for slave unit 1 and slave unit 2 must be made.
Must match the number of slave units set on the master unit to that set on the slave units.
Table: The number of slave units and settings
Number of slave units Settings of master unit Settings of slave unit 1 Setting of slave unit 2
0 Slave Unit 0 Not connected Not connected
1 Slave Unit 1 Slave No. 1 Not connected
2 Slave Unit 2 Slave No. 1
Slave No
．
2
Note that the unit will not operate properly if a slave unit is set to Slave Unit 2 even though there is only
one slave unit or if two slave units are set to Slave Unit1 or Slave Unit2.
[Settings of the slave units]
On the Main Set 2 of the slave unit, there is an item for setting the number of slave units.
In order to perform the master/slave operation, be sure to set the number of slave units connected first.
Press the SET/SAVE switch to enter the setting state, use the downward "
▼
" movement switch to select
"MORE" and press the ENTER switch to open Main Set 2.
Use the downward "
▼
" movement switch to select "Slave No." and set the number of slave units by
turning the DIAL.
Then press the SET/SAVE switch to save the setting.
When changed the settings for the slave units, be sure to save the settings, set the POWER switch to OFF,
and then set the POWER switch to ON again to restart the unit.
Without rebooting the units, it may not operate properly.
Fig. Main Set 2 on slave
unit
Number of slave
units
Main Set
２
Matsusada
LOC
DC
Ext Signal
Soft Start
Soft Stop
SYSTEM
Response
Sense
Slave No.. 1
CV
AC
OFF
FAST
OFF
Vdc +10.003 V
Vrms 14.138 V
Irms 28.295 A
Idc +19.991A
＜
SLAVE
１＞