Matrox Iris GTX Series, Installation And Technical Reference, Page: 59 / 100

Matrox Iris GTX specifications 59
GTX2000, GTX2000C, GTX5000, GTX5000C, GTX8000, GTX8000C, GTX12000, GTX12000C, GTX16000, GTX16000C
I/O specifications
Opto-isolated output signals Operating voltage 24 V (26 V abs. max)
Sink current 50 mA max
Maximum leakage current 1 μΑ @ 24 V
1 m Α @ 26 V
ON voltage 0.4 V @ 2 mA
1.1 V @ 25 mA
1.5V @ 50 mA
PTC
a
fuse max. time-to-trip
1 sec @ 0.5 A
OFF to ON response
2 μ sec to reach 4 V
b
ON to OFF response
50 μ sec to reach 11 V
b
Opto-isolated input signals Operating voltage 24 V (26 V abs. max)
Input current (sink or source)
c
3.5 mA max
d
, 1 mA min
e
ON voltage level
> 11 V
f
OFF voltage level < 4 V
OFF to ON response 6 μ sec
ON to OFF response 80 μ sec
0-10 V analog control output signal Non-isolated. Supports lighting devices (such as, an Advanced Illumination inline control
system (ICS3), a Smart Vision Lights Brick light, or a similar device).
Note that the 0-10 V is intended for reference voltage only (that is < 1 mA).
a. The PTC is an automatically resetting fuse.
b. This occurred under the following condition: output pulled to 24 V using 1 k
Ω.
c. Regardless whether the signal is sinking or sourcing, this measurement is the same.
d. Maximum input current at maximum ON voltage. Note that the connected device must not limit the current to a value lower than this.
e. Minimum input current at minimum ON voltage. This can be used to calculate bleeding resistor needed for 2-wire proximity sensor.
f.
Recommended > 12 V when using Matrox I/O Breakout Box.