Matrix E5x-02, Service Manual

Page: 35 / 74

31
8.6 driVE bElt rEplacEMEnt
1) Turn off the power and disconnect the cord from the machine.
2) Remove the right side front disk from the machine as outlined in Section 8.1.
3) Loosen the belt tension screw on the left side of the tension pulley and rotate the pulley counter clockwise until there is enough slack in the belt
to remove it (Figures A & B).
4) Walk the new drive belt into position on the drive assembly.
5) Once the drive belt is in place, reapply tension by rotating the tension pulley clockwise until there is 170 ft / lbs of tension on the belt. Tighten
the belt tension screw to hold the tension pulley in place (Figure C).
6) Reinstall the front shroud and disk.
7) Test the Elliptical Trainer for function as outlined in Section 8.21.
figUrE a figUrE b
figUrE c
cHaptEr 8: part rEplacEMEnt gUidE