Matrix E5x-02, Service Manual

Page: 34 / 74

30
8.5 Ecb bElt rEplacEMEnt
1) Turn off the power and disconnect the cord from the machine.
2) Remove the left side front disk from the machine as outlined in Section 8.1.
3) Remove the left side shroud from the machine as oultined in Section 8.2.
4) Remove the screw holding the ECB axle in place on the right side of the frame (Figure A).
5) Loosen the large nut on the tension eye bolt on both sides of the frame (Figure B).
6) Remove the tension eye bot nut from the ECB bracket on both sides of the frame (Figure C).
7) Once the tension eye bolts have been removed, slide the ECB towards the back of the unit and off of the ECB bracket (Figure D), this will allow
you to remove the ECB belt from the ECB and pulley axle set (Figure E).
8) Reverse Steps 1-7 to install a new ECB belt. note: Be sure to tighten the new ECB belt to 85 ft / lbs using the ECB eye bolts.
8) Test the Elliptical Trainer for function as outlined in Section 8.21. .
figUrE a figUrE b figUrE c
figUrE d figUrE E
cHaptEr 8: part rEplacEMEnt gUidE