Matrix E5x-02, Service Manual

Page: 33 / 74

29
8.4 Ecb (ElEctronic brakE) rEplacEMEnt
1) Turn off power and disconnect the cord from the machine.
2) Remove the front disks as outlined in Section 8.1.
3) Remove the front shrouds as outlined in Section 8.2.
4) Unplug the ECB wire harness from the lower control board (Figure A).
5) Remove the screw holding the ECB axle in place on the right side of the frame (Figure B).
6) Loosen the large nut on the tension eye bolt on both sides of the frame (Figure C).
7) Remove the tension eye bot nut from the ECB bracket on both sides of the frame (Figure D).
8) Once the tension eye bolts have been removed, slide the ECB towards the back of the unit and off of the ECB bracket (Figure E).
9) Reverse Steps 1-8 to install a new ECB. note: Be sure to re-tension the ECB belt to 85 ft / lbs using the tension eye bolts.
10) Test the Elliptical Trainer for function as outlined in Section 8.21. .
figUrE a figUrE b figUrE c
figUrE d figUrE E
cHaptEr 8: part rEplacEMEnt gUidE