45
7.16 liNK aRM REplacEMENt - coNtiNUED
cHaptER 7: paRt REplacEMENt gUiDE
figURE E
figURE f
figURE g
figURE H
4) Remove the 3 screws holding the pedal assembly to the pedal arm (Figure E). Remove the hardware and 3 hole plate.
5) Slide the link arm assembly off of the pedal arm (Figure F).
NOTE:
Make sure to notice the order of the washers for reinstallation (wavy,
Teflon, pedal assembly, Teflon, 3 hole plate, screws).
6) Peel up the pedal foot pad, and remove the 4 screws holding the pedal to the link arm (Figures G & H).
7) Reverse Steps 1-6 to install a new link arm.
8) Test the elliptical trainer for function as outlined in Section 7.21.
Summary of Contents for E1X
