Matrix E1X, Service Manual

Page: 67 / 71

63
1) Remove the 4 screws and plate from the front side of the console mast (Figure A).
2) Fish the TV power wire and coax cable from within the console mast and push it out the hole in the front of the console mast (Figure B).
NOTE: You may need to remove the console to get these 2 wires out.
3) Remove the protective coating from around the coax cable (Figure C).
4) Connect the coax cable and power wire from the console mast with the cables coming from the TV bracket (Figure D). NOTE: You will need
to use a coax adaptor sent with the bracket (Figure E). Be sure to orientate the TV bracket the correct way when installing.
5) Attach the TV bracket to the console mast using the 4 screws removed in Step 1 (Figure F).
6) Attach the small bracket to the TV bracket using the hardware provided. There should be 1 lock washer and 3 flat washers on each side
(Figure G).
7) Attach the TV to the TV bracket using 4 silver screws sent with the TV (Figure H).
8) Connect the coax and TV power wire to the TV (Figure I).
9) Unbox the power cord from the TV box and plug into the port at the bottom front of the elliptical trainer (Figure J).
10) Run a coax cable to the elliptical trainer and plug it into the port at the bottom front of the elliptical trainer (Figure K).
11) Remove the protective film from the TV screen (Figure L).
12) Test the TV for function, program for channels as needed.
figURE a
figURE b
figURE c
figURE D
8.6 tV bRacKEt iNStallatioN
cHaptER 8: Elliptical SpEcificatioNS aND aSSEMbly gUiDE