Receiving a call from Mobile to FXS
•
From the cell-phone, dial the number of the SIM Card (inserted in SIMADO
GFX44) provided by the GSM Service Provider.
•
The analog phone connected to the SIMADO GFX44 will ring. Please make
sure that analog phone should be connected to FXS1 Port of SIMADO
GFX44.
•
Lift the handset. You will be in speech with the cell-phone.
•
Replace the handset of analog phone to disconnect the call.
If the system consists of 4 SIM Cards and 4 analog phones connected then
the call will follow the below mentioned route:
Incoming Calls on Mobile port
The 1st calls from GSM network (on any Mobile Port) will land on the FXS1 Port
(if free). The next consecutive call on any Mobile Port will select the next free
FXS Port in ascending order of selection.
Outgoing Calls from FXS port
The call made from any FXS Port will select the 1st Mobile port (if free). The next
consecutive call from any FXS Port will select the next free Mobile Port in
ascending order of selection.
Appendix
FAQs
Q.1.
LED is not glowing after power up?
Ans.
Check the power supply between mains and DC jack of SIMADO
GFX44.
Q.2.
I do not have PC to use serial Jeeves for configuration. Can I still
change the system configuration?
Ans.
Yes, you can enter into programming mode using command
#-19-
1234
followed by SE Password 1234 either from FXS or Mobile port
and change configuration by issuing system commands.
Summary of Contents for SIMADO GFX44
Page 1: ...SIMADO GFX44 Quick Start ...
Page 2: ......
