MasterCraft NXT20 2017, Owner'S Manual

Page: 55 / 238

2017 OWNERS MANUAL / 104
This screen displays any faults that have occurred for the Outputs,
Inputs and/or CAN Communication.
Faults are color coded as follows:
• Red (Short Circuit or Out of Range)
• Orange (Open Circuit)
• Yellow (Over-Current)
• Green (No Faults / Active / In Range)
To reset existing faults, touch.
To display the alternate PDM Diagnostics screen, touch
/ .
EPDM & ENGINE DIAGNOSTICS
Models
All X Series and XT Series models equipped with optional HV700
Touch Screen
Purpose
The EPDM is a solid state engine fuse block designed for all 2017
MasterCraft boats to make engine diagnostic checks easier and
more convenient for quick, on the water fixes.
Location
The EPDM screen is accessible via the HV700 Touch Screen. To
Engine Diagnostics
On the Diagnostics Menu screen, touch the
Touch Command to access the Engine Diagnostics screen.
Field definitions on the Engine Diagnostics screen:
Active Faults/Stored Faults
Shows the number of active faults and which fault number is
currently being displayed. To advance to the next fault, touch
[NEXT]. Touch [PREV] to go back to the previous fault. Touching
[BACK] returns to the Settings Menu.
SPN — Suspect Parameter Number — fault code. If not
translated into text by the display, see the engine
manufacturer’s literature for the definition of the SPN number.
FMI — Failure Mode Indicator — fault code. The FMI is defined
by SAE J1939. If not translated into text, see the SAE standard,
or the engine manufacturer’s literature.
Description Field — Most common SPNs and FMIs have text for
the description stored in the display. If there is no text, then this
SPN and FMI must be defined by referring to the engine manu-
facturer or the SAE J1939 standard.
NOTE: This field is only used with certain engine models.
Corrective Action
This shows the suggested action for correction of the faults.
Get Faults
Touching [Get Faults] queries the engine(s) ECU for feedback on
diagnostic codes activated and stored in the ECU for service needs.
PDM Diagnostics
On the Diagnostics Menu screen, touch the
Touch Command to access the PDM 1 Diagnostics screen.
Factory Settings
On the Settings Menu screen, touch the Touch
Command to access the Factory Settings screen. A Dealer code is
required to access this screen.
Once the appropriate code is entered, click Done. The following
screen will appear:
Factory Reset will reset all the parameters that have been changed
since the factory set them. Dealer Info will allow the editing of the
address, phone, etc. of the boat dealer.