headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
model no. 054-6841-4 | contact us 1-800-689-9928
16
NOTE:
Failure to make sure the router mounting plate is flush with the tabletop surface can result in poor routing performance.
Slide a square-cut board from right to left across the router mounting plate to be sure that the board moves smoothly.
ATTACHING THE ROUTER TO THE ROUTER TABLE
1. Unplug the router and the router table.
2. Remove the plastic sub-base from the router base
(fig 4).
3. Loosen the screws and remove the universal router
mounting plate from the router table.
4. Put the router upside down, and align the three holes
in the centre of the universal router mounting plate
with the holes in the router, as shown in fig 3.
5. Insert a flat-head screw (11) through each of the
three holes in the universal router mounting plate
and into the holes in the router base, and then
tighten each flat-head screw securely (fig 5).
6. Re-install the router mounting plate to the router
table (fig 6a). Install the four levelling screws into the
four holes around the mounting plate opening. Adjust
the mounting plate height so that it is flush with the
table (fig 6b). A turn to the right raises the mounting
plate and a turn to the left lowers the plate. Using a
straight edge, check to be certain that the surface of
the router mounting plate is flush with the tabletop
surface.
7. To hold the mounting plate in position, tighten the
four screws in Step 3. Recheck to make sure that the
surface of the router mounting plate is flush with the
tabletop surface. If not, repeat Step 6.
OPERA
TING INSTRUCTIONS
fig 4
fig 5
fig 6a
fig 6b
Summary of Contents for 054-6841-4
Page 32: ......
