headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
23
USING A VACUUM
The vacuum adaptor in the fence assembly is 2 1/2” (6.4 cm) in diameter. Select the vacuum
accordingly.
GENERAL ROUTING OPERATIONS WITH THE ROUTER TABLE
1. Read and understand entire Instruction Manual for the router.
2. Always plug the router into the switched outlet in the router table. Never plug a router-table-mounted
router into another power source.
3. Make sure the router-table switch is off. Lock the router switch in the ON position.
4. Reconfirm that all router adjustments are securely locked before supplying power to the router.
5. Plug the power cord for the router table into a power source.
6. Turn on the power to the router table by pulling up on the ON/OFF switch.
7. Always control the power to the router with the switch on the router table whenever the router is mounted
on the table.
8. Adjust the fence to support the workpiece to be cut.
9. Always feed the workpiece from right to left.
WARNING!
• Operating the router table without a vacuum can result in an excessive build-up of sawdust and wood chips
under the fence assembly and guard and in the cabinet, reducing the performance of the router table and
fence assembly.
• The direction of feed for the workpiece is always against the sharp edges of the cutter, and into the rotation
of the cutter. When installed in a router table, the direction of cutter rotation is counter-clockwise. Failure to
follow this rule can result in serious personal injury.
FPO
NOTE:
The workpiece must always be held tightly against the fence.
OPERA
TING INSTRUCTIONS
Summary of Contents for 054-6841-4
Page 32: ......
