headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
model no. 054-6841-4 | contact us 1-800-689-9928
18
ATTACHING THE MITRE
GAUGE
(fig 9)
1. The mitre gauge is shipped completely assembled.
2. Attach the mitre gauge to the table by placing the
mitre-gauge bar in the slot on the table.
3. To adjust the mitre gauge, loosen the mitre gauge
knob, rotate the mitre gauge to the desired angle and
tighten the knob again.
ATTACHING THE TABLE TO A WORK
SURFACE
(fig 10)
1. Place the router table upright on a sturdy surface, such
as a work stand, workbench, or countertop.
2. While holding the router table in place, mark the
location of the two mounting holes (11/32” [8.7 mm]
diam.) in each of the legs on the work surface.
3. Remove the router table.
4. Drill a hole into the work surface at each of the
marked locations.
5. Place the router table on the work surface and align
the holes in the table legs with the holes in the work
surface.
6. Secure the router table to the work surface with four
bolts and nuts (not included).
7. Tighten the bolts securely.
OPERA
TING INSTRUCTIONS
fig 9
fig 10
Summary of Contents for 054-6841-4
Page 32: ......
