4
Troubleshooting
Problem:
Blade speed slow or erratic
Cause:
Menu Items 1 or 2 are set too low
Solution:
Refer to the Menu Items 1 and 2 in this manual to check
and change the speed settings
Cause:
Laser Transmitter is not set on minimum required RPM
Solution:
Make sure the Laser is set to at least 600 RPM
Problem:
System not responding fast enough
Cause:
Laser Transmitter is not set on minimum required RPM
Solution:
Make sure the Laser is set to at least 600 RPM
Problem:
Mast Speed slow or non-responsive
Cause:
Menu Item 3 is set too low
Solution:
Refer to the Menu Item 3 in this manual to check and
change the speed setting
Problem:
No Lights on Control Panel
Cause:
Loose, dirty or damaged cable
Solution:
Inspect power cable and connectors for damage or dirt
and make sure it is connected properly. If damaged, call
to order a replacement.
Problem:
No signal to Receiver
Cause:
Loose, dirty or damaged cable
Solution:
Inspect Mast/Receiver cable and connectors for damage
or dirt and make sure it is connected properly. If
damaged, call to order a replacement.
Cause:
Laser Transmitter not working properly
Solution:
Check to make sure Laser Transmitter is working
properly
Cause:
Laser Beam Obstruction
Solution:
Make sure nothing is obstructing the laser beam
Summary of Contents for Laser Tech 304
Page 8: ...Revised 11 2019 ...
