Exterior Projection 500 User Manual
41
6. See illustration on
right. Carefully cut
the cable tie on
the gobo module
wireset to give
more free length
in the wireset.
7. Plug the large
multi-connector
into the framing
module and the
smaller multi-
connector into the
color wheel
module.
8. See illustration below. Route the wireset around the left-hand side of the framing module, and
then fasten the framing module into the fixture with the two Allen (hex) screws (arrowed) that
were used to fasten the gobo module into the fixture. The illustration below shows the framing
module cover being opened with an Allen key / hex wrench, but the screws that hold the
framing module into the fixture are indicated with arrows.
9. If you are not going to adjust framing immediately, close the fixture as described in ’Removing
and reinstalling the top cover’ on page 32. If you are going to adjust framing, continue to the
next section below.
Summary of Contents for Exterior Projection 500
