Martin Exterior 400, User Manual

Page: 3 / 44

Safety Information
The following symbols are used to identify important safety information on the product and in this manual:
WARNING! Risk Group 2 LED product according to EN 62471. Do not look into the beam at a
distance of less than 8.3 m (27.3 ft.) from the front surface of the product. Do not view the light
output with optical instruments or any device that may concentrate the beam.
This product is for professional use only. It is not for household use.
This product presents risks of severe injury or death due to fire hazards, electric shock and falls.
Read this manual
before installing, powering or servicing the fixture, follow the safety precautions listed
below and observe all warnings in this manual and printed on the fixture. Install and operate the fixture only
as described in this manual and in accordance with local laws and regulations. Refer any operation not
described in this manual to an authorized Martin Service partner.
Terminal block not included.
Installation may require advice from a qualified person.
If you have any questions about how to install or operate the fixture safely, please contact your Martin
supplier or call the Martin 24-hour service hotline on +45 8740 0000, or in the USA on 1-888-tech-180.
P R O T E C T I O N F R O M E L E C T R I C S H O C K
• Shut down power to the entire installation at the main power distribution board and ensure that it cannot
be reapplied, deliberately or accidentally, before carrying out any installation or maintenance work.
• Disconnect the fixture from AC power before removing or installing any cover or part and when not in use.
• Connect the fixture electrically to ground (earth).
• Use only a source of AC power that complies with local building and electrical codes and has both
overload and ground-fault (earth-fault) protection.
• Connect the fixture to AC power using the supplied power cable only. The power and data cables
supplied with the fixture may only be replaced by Martin Professional or its authorized agents. If either of
the supplied cables is in any way unsuitable, contact Martin Professional for assistance.
• Before using the fixture, check that all power distribution equipment and cables are in perfect condition,
are rated for the current requirements of all connected devices, are protected to IP67 or higher and are of
suitable type for the location (including water, pollution, temperature and UV resistance).
• Isolate the fixture from power immediately if any cable, seal, cover or other component is damaged,
cracked, deformed or shows signs of overheating. Contact Martin Professional for assistance and do not
reapply power until repairs have been completed.
WARNING!
Read the safety precautions in this section before
installing, powering, operating or servicing this
product.
WARNING!
Safety hazard.
Risk of severe
injury or death.
WARNING!
Hazardous
voltage. Risk of
lethal or severe
electric shock.
WARNING!
LED light
emission. Risk
Group 2 LED
product
according to EN
62471.
WARNING!
Fire hazard.
WARNING!
Refer to user
manual.