Martin Exterior 400, User Manual

Page: 33 / 44

Service and maintenance
33
• A Martin DABS 1™ PC/fixture hardware interface box (supplied in a package with the Martin MUM™
application) and a Windows PC.
Installing software
1. Connect the uploader hardware to a Exterior 400 Image Projector fixture’s data input connector. The
software will be uploaded to that fixture and all fixtures of the same type that are powered on and
connected via the DMX link.
2. Upload the fixture software as described in the uploader’s help file or user documentation.
3. Disconnect the uploader hardware and reconnect the fixture to the DMX link.
4. Cycle power off and on. Check that the fixture resets correctly and behaves normally. If it does not, cycle
power off and on again and check that the fixture now resets correctly and behaves normally. If the
problem persists, contact Martin for assistance.
Status indicator LEDs
Two LEDs on the rear cover give information about fixture status.
LED 1 (DMX / data status)
• Lights steady red if the fixture
receives data it cannot recognize.
• Lights steady green when the
fixture is successfully receiving a
DMX signal.
• Flashes green when the fixture is
successfully receiving a data
signal (e.g. RDM).
• Lights steady yellow during a
software upload.
• Flashes yellow while the fixture is
resetting.
LED 2 (Fixture status)
• Flashes red if an error occurs that
requires service intervention.
• Lights steady green when the
fixture is ready for operation.
• Lights steady yellow during a
software upload.
• Flashes yellow while the fixture is resetting.
• Does not light at all if power is not applied to the fixture.
Adjustment
The
Adjustment
window in MUM is for use by service technicians only. Do not use any commands in this
window unless specifically instructed to do so by Martin™ Service personnel. If you alter the factory
settings, there is a risk that you will cause unsatisfactory performance.
Figure 19: Status indicator LEDs