Control Panel
13
F I R M W A R E V E R S I O N
→
displays the firmware version number. The firmware version is also displayed briefly at
startup.
Test and service utilities
D M X R E A D O U T
The D=c log (
) menu provides useful information for troubleshooting control problems.
displays the D=c refresh rate in pac7ets per second. aalues lower than 10 or higher than 44 may
result in erratic performance, especially when using trac7ing control.
displays the Yuality of the received D=c data as a percentage of pac7ets received. aalues much
below 100 indicate interference, poor connections, or other problems with the serial data lin7 that are the
most common cause of control problems.
displays the D=c start code. Qac7ets with a start code other than 0 may cause irregular
performance.
The remaining options under
display the D=c values received on each of the 13 channels, from
(shutter, channel 1) to
(effect speed, channel 13). If the fixture does not behave as expected,
reading the D=c values can help you troubleshoot the problem.
M A N U A L C O N T R O L
The manual control menu (
) provides commands for turning the lamp on (
), turning the lamp off
(
), and resetting the fixture (
). It also permits you to position and move individual effects.
E F F E C T S T E S T
The test seYuence (
→
) runs through all effects to provide a Yuic7 chec7 of fixture performance.
Note: the test seYuence does not automatically stri7e the lamp. ]se
→
and
→
to
control lamp power. Qress lmenum to stop the test.
F E E D B A C K T O G G L E
=agnetic sensors monitor the positions of the color wheel, gobo wheel, and rotating gobos. If they detect an
error, the shutter closes while the effect resets. This feature can be disabled by turning effects feedbac7 off
(
→
→
).
A D J U S T M E N T P O S I T I O N S
The adWustment menu (
→
) provides commands for positioning effects during mechanical
adWustment.
E F F E C T C A L I B R A T I O N
_ith the calibration menu (
→
), effect positions can be fineKtuned with a softwareKdefined offset
value to compensate for small misalignments or differences between fixtures.
The default offset command (
→
) erases any offsets stored in memory.
C I R C U I T B O A R D T E S T
→
executes a routine designed for testing the main circuit board. Por service use only.
U P L O A D M O D E
The upload mode command (
→
) prepares the fixture for a software update. This command is
not necessary, however, as upload mode is engaged automatically by the uploader.
Summary of Contents for MAC 250 Entour
