9
8
Chapter 8 : TECHNICAL SPECIFICATIONS
The technical specification details of Premier Combo Plus Digital
TENS/EMS are as follows:
MECHANISM
TECHNICAL DESCRIPTION
01 Channel
Dual, isolated between channels
02 Pulse Amplitude Adjustable, 0-100 mA peak into 500 ohm
load each channel.
03 Wave Form
Asymmetrical Bi-Phasic Square Pulse
04 Voltage
0 to 50V (Load: 500 ohm)
05 Power source
One 9 Volt Battery.
06 Size
11.8cm(L) x 6 cm(W) x 3.1cm(H)
07 Weight
157 grams with battery.
08 Pulse Rate
Adjustable, from 2 to 150 Hz, 1 Hz/step
09 Pulse Width
Adjustable, from 50 to 300 microseconds,
10 µs/step
10 On Time
Adjustable, 2~90 seconds , 1 Sec./ step
11 Off Time
Adjustable, 2~90 seconds , 1 Sec./ step
12 Ramp Time
Adjustable, 1~8 seconds, 1 Sec./ step, The
“On” time will increase and decrease in
the setting value.
13 Mode
Six TENS Modes: B(Burst), N(Normal),M
(Modulation Rate & Width),S1( Modulation
Width), S2 (Modulation Width) and P
Three EMS Modes:C(Constant), S
(Synchronous), A(Alternate)
14 Burst Mode
Burst rate: Adjustable, 0.5 – 5Hz
Pulse width adjustable, 50~300µs
Frequency fixed = 100 Hz
15 Normal Mode
The pulse rate and pulse width are
adjustable. It generates continuous
stimulation based on the setting value.
16 Modulation Mode Modulation mode is a combination of pulse
rate and pulse width modulation. The pulse
rate and width are automatically varied in
a cycle pattern. The pulse width is
decreased by 50% from its original setting
BACK
SIDE
BACK
(10)
BELT CLIP
(11)
BATTERY STRIP
(12)
BATTERY CASE
SIDE
(13) KEY LOCK FACILITY
Liquid Crystal Display
1. INTENSITY LEVEL
2. MODE
3. SETTINGS
4. STIMULATION TYPE
5. LOW BATTERY INDICATOR
6. LOCK
