25
24
Chapter 20 : ADJUSTING THE CONTROLS
1. Power On/Off/Pause Button
The power of unit can be turned on by pressing the On/Off/
Pause button. You may start to adjust the settings when the
liquid crystal is light up. Press and hold for 2 seconds to switch
off. To pause stimulation press the button once. To resume
stimulation press the button again and stimulation will be restored
in 2 seconds.
If the unit is not used (buttons not pressed or output level at 0)
for 5 minutes, the power will be shut off automatically.
If the unit is not used(buttons not pressed or output level at 0) for 5
minutes, the power will be shut off automatically
2. Lead Connector
Connection of the electrodes is made with the two-lead connector
(lead wires) on the top of unit. The device must be turned off
before connecting
the cables.
Electrodes must be in
firm contact
with the skin.
Pause
3 Mode Control
There are 5 TENS modes(B, N, M, S1, S2) and 3 EMS modes
(C, S, A) available. The mode is selected by pressing the “Mode”
control. When a TENS mode is selected, the LCD shows
"TENS". When EMS mode is selected, the LCD shows "EMS"
4. Set Control
By pressing the "Set" control you select the
setting you intend to adjust. The value is set
by pressing the "Increment" or "Decrement"
controls when the "Set" value is flashing.
5. Increment Control
This button controls the increase of settings.
6. Decrement Control
This button controls the decrease of settings.
7. Intensity Increase Control
The intensity level can be increased by pressing this button.
There are 99 steps of intensity adjustment control. Press the
button until the desired intensity level is reached.
8. Intensity Decrease Control
The intensity level can be decreased by pressing this button.
There are 99 steps of intensity adjustment control. Press the
button until the desired intensity level is reached.
9. Key Lock Facility
Pressing the "Lock" buttons prevents the settings
