Mark OptiTherm Plus 06 29 189, Technical Manual, Page: 5 / 140

2.2 Factory settings
• Temperature
: Day 18°C
ECO 15°C
Night 08°C
Frost 05°C
•
Clock program : Program block 1
Day 12345
Switch time 08:00 >> 17:00
Switch to Day
•
Exception day : off
•
overtime timer : Maximum setting time 03:00hrs
Switch to Day
•
Selection temperature sensor : Sensor Thermostat
•
Calibrate temperature sensor : 0.0°C
•
Summer / winter time : Automatic
•
Pin code : 1 0 0 0
3.0 Installation and initial starting
3.1 General
•
After unpacking check the Op and if also ordered, the external sensor(s) delivered
with it for damage.
•
At the same time check the correctness of the type/model
(Thermostat: Op 06 29 189, external sensor: Digital sensor conc. 2 Wires 06 29
194).
Contact the supplier if the thermostat is damaged or it is not the correct type/model.
3.2 Positioning
In order to determine an appropriate place to mount the Op you must consider the
points below:
– Place the Op in the room to be heated, because it is supplied with an internal room
sensor. This is not applicable when an external sensor (optional deliverable) connected to the air
heater(s).
– Mount the Op in a draft free location
– Do not mount the Op on a cold wall/partition.
– Do not mount the Op directly in the airflow of the air heater(s).
– It is advised to place the Op at a distance of ±1.5m from the floor.
3.3 Cabling
For the cabling a protected bus cable must always be applied.
Also see table
[2] for the maximum length and the proper diameter.
Attention!
The cable protection is earthed on the air heater.
5
EN