Mark OptiTherm Plus 06 29 189, Technical Manual, Page: 20 / 140

20
Burner check
Possibility of checking the ionizing current of the of the unit concerned.
Self learning heating
To read out the Self Learning Heating.
Possibility to manually set the Self Learning Heating to a fixed value.
Possiblity to set the minimum time of which the unit must be in operation during the heating
curve.
Room Controller
Setting P band
Setting I time
Hysteresis UP: maximum temperature exceedance of the desired temperature at which the unit
stays in operation.
Hysteresis DOWN: maximum temperature deviation lower than the desired temperature, at
which the unit must come back into operation.
Supply temp max: maximum supply temperature of the unit
Supply temp min: minimum supply temperature of the unit
5.18 Recover factory settings
When you execute this function all settings in the Op are reset to the factory settings
§2.2
. This function can be executed at any time. Follow the image below to execute this function:
OK
select
to next digit
OK
modify
Date/Time
Time
Date 01 - 03 2011 -
: 08 00
18.0 °C
01-03-2011
09:00
0 . 5 1
Language
Nederlands
Deutsch
Français
English
English
18.0 °C
01-03-2011
09:00
0 . 5 1
ESC OK
Reset
RESTORE
FACTORY DEFAULT
OK-CONTINUE
ESC-BACK
ESC
OK
OK
±12sec.
•
Keep pushing the
ESC
button and the
OK
button simultaneously for +/- 12 seconds until
the text ‘Factory Settings’ is displayed on the screen.
•
Only applicable when you wish to recover the factory settings
To execute, press the
OK button. The factory values are recovered and the language, date
and time must be entered again. For this, also see §3.5 First Initial Operation
•
Only applicable when you do not wish to recover the factory settings
Press the
ESC button to quit the function again.
The main display is shown again and the factory values are not reset.