Mark OptiTherm Plus 06 29 189, Technical Manual

Page: 16 / 140

16
You can change this following the image below:
OK OK
ESC ESC ESC
select select modify
ECO fan function
2x
OK
to next digit
Calibrate
Deviation
Sensor
0.0 K
Room Control
Calibrate
Deviation
Sensor
0.0 K
Room Control
back to main screen
Settings
Calibrate
Date/Time
Overtime setting
Select Temperature sensor
•
Now with the  and  button, select Calibrate Thermostat and then push the OK button
•
Only applicable when an external sensor is also used.
•
With the  and  button, select Sensor and then push the OK button
•
Only applicable when an external sensor is also used.
•
Now with the  and  button select the air heater (1 to 8) from where the external
sensor must be calibrated and then push the
OK
button.
•
With the  and  button, select Deviation and then push the
OK
button
•
With the

and

button set the desired value and confirm this with the
OK
button.
•
When you have finished with the changes you leave the menu item by pressing the
ESC
button and you go back to the settings menu.
•
Now select another item to change or to go back to the user menu by pushing the ESC
button. Push the ESC button again to go back to the main display.
5.10 Settings menu: ECO fan function
With the ECO fan function it is possible to turn on the fan of the unit when the temperature near
the unit is higher than that of the Op or, if applicable, the external sensor. With this
function it can be prevented that the warm air stays at the top of the room.
To turn on the fans in this function, all of the following requirements need to be met:
•
There must have been a burner demand in the past 24 hours
• The temperature near the unit must be higher than: s1K,s2 – s 5K
(depending on the settings)
• The temperature difference measured at the Op and near the unit, must be greater
than 0,0 – 10,0K (depending on the settings)
You can change the settings of the ECO fan function following the image below:
•
OK OK
ESC ESC ESC
back to main screen
select modify
Settings
Overtime setting
Select temperature sensor
Calibrate
ECO fan function
2x
ECO fan function
Ecofan Setpoint
Function
Se 1K
On
ECO fan function
Self Learning Heating
Delta T 3.0 K
Ecofan Setpoint
Function
Se 1K
On
Delta T 3.0 K
select
Select the menu-item ECO fan function and then push the OK button.
• Select Function to turn the ECO fan function on or off.
•
With the  and  button, select the required setting and then push the OK button.