9
|
|
Abbreviated Operator’s Guide
|
CS300
™
|
OPERATOR INTERVENTION
for No Trigger
n
Reattach or reposition the electrode and check the integrity of all cable/lead
connections.
n
Switch Operation to
SEMI AUTO
and increase the ECG Gain setting in the
PUMP OPTIONS
menu.
n
Use IAB Inflation and IAB Deflation controls to adjust timing and resume pumping by
pressing the
START
key.
n
Verify that the transducer was not left vented; check all transducer cable
connections.
n
Attempt to restore A.P. pulse height by flushing the circuit.
for Poor Signals Persist
n
Attempt to restore A.P. pulse height by flushing the circuit, verify transducer
was not left vented; check integrity of all cable connections.
n
Attempt to improve ECG signal by ensuring electrode contact and optimal
placement.
n
If signal problem persists, switch Operation mode to
SEMI AUTO
. Verify
trigger source.
n
Use IAB Inflation and IAB Deflation controls to adjust timing and resume pumping by
pressing the
START
key.
ALARM MESSAGE [SEMI AUTO OR
MANUAL OPERATION MODE]
PROBABLE CAUSE
No Trigger
Valid trigger, as defined in Specification section,
does not exist or is lost in ECG or Pacer Trigger
mode.
No Pressure Trigger
Valid trigger is unavailable or is lost while in
Pressure Trigger.
Check Pacer Timing
The patient is not 100% paced or V/A-V pacer
trigger interval varies >25% or an A-V pacer
rate is >125 bpm.
Trigger Interference
Electro-Surgical Noise [ESU] detected while the
Pacer Trigger Source is selected.
ECG Detected
(Pumping is NOT suspended)
ECG activity is detected persistently for 4-6
seconds while in the Internal Trigger mode.
VAULT COPY