D
4.1
With the extruder assembly in place, collect the right
X axis assembly
that we assembled earlier.
Using a soft mallet, gently insert the X axis assembly onto
the linear rods.
Take care not to damage the X assembly or linear rods.
If you find it particularily difficult, you can remove the 4
screws holding the motor assembly, and use the back-
side of X axis to hammer against directly. The linear rods
should be flush with the backside of the X axis assembly.
N/A
59
17
Summary of Contents for Mini V2
