D
4.1
10
11
N/A
N/A
53
Place the
GT2 Pulley
onto the shaft of the
stepper motor.
Use the
small hex wrench
to slightly tighten
the grub screw to hold the gear in place.
We will need to fine-tune the pulley’s location
later in this guide, so do not tighten the screw
completely.
From the hardware kit, select one of the
remaining
48mm stepper motors,
as well as
the
GT2 Pulley
.
Summary of Contents for Mini V2
