![background image](http://html1.mh-extra.com/html/3d-systems/projet-1200/projet-1200_quick-setup-manual_3134956001.webp)
Open the box
Pull the tabs on both release clips (A), one
on each side. Remove the clips from the
outer box by pulling them out. Lift the
outer box off the printer.
Remove the upper foam
support
Remove the upper foam support (B).
Carefully lift machine out of box (C).
Remove the bottom foam support (D).
Open peripheral boxes
Peripheral boxes contain: USB cable (A),
print platform (B), curing bulb (C), power
supply (D) and material cartridge (E).
Place Printer
Place printer in a place where there is not
too much natural sunlight and it is level.
Remove protective film covering the
display (A).
Install curing bulb
Open curing door and hold the curing
bulb with tissue or paper towel, with
notch facing up. Insert end of bulb down
in hole behind carousel and insert bulb
base up into socket ensuring it locks in
place.
Remove the peripherals box
Lift off the peripherals box (A) and place it
to the side.
Install print platform
1. Rotate the print platform clamp lever
upward.
A
B
A
C
D
A
D
E
C
A
B
Hold bulb with tissue
or paper towel to
avoid damaging.
2. Insert the print platform under the
clamp lever until it is seated (A).
Rotate the print platform clamp lever
down to lock the print platform (B).
Remove Insert
Open the print door and pull up the
cartridge clamp lever (A) and remove
the plastic insert (B) from the material
cartridge support.
A
Installing Material Cartridge
1. Lift the material cartridge clamp lever
(A) up to raise the cartridge clamp.
2. Remove cartridge from foil package,
cut end with scissors.
NOTE: Look in the foil bag to
ensure there is no resin inside
bag. If resin is present do not insert
cartridge in the machine.
3. Check material cartridge to ensure
tab is folded over and facing the front
of machine, if not, fold over now.
A
4. Insert the material cartridge into the
material cartridge support and then
under the material cartridge clamp.
NOTE: The material cartridge will
set into a pocket on top of the
glass pane.
CAUTION: It is very important
that the cartridge be seated
correctly in the pocket or else
a leak can be created in the cartridge
which may damage the system.
A
B
ProJet 1200™
Setup
Please refer to the ProJet1200 User Guide for safety and comprehensive operating instructions. You can find the ProJet 1200 User Guide on 3DSCentral.com.
SAVE ALL FOAM AND PACKING MATERIAL FOR FUTURE USE. SHIPPING WITHOUT THE ORIGINAL PACKING MATERIAL MAY CAUSE DAMAGE TO THE PRINTER.
NOTCH
B
5. Rotate the material cartridge clamp
lever (B) down to lower the cartridge
clamp (A).
NOTE: Ensure the clamp is locked.
If the clamp requires a lot of
pressure to lock, check that the cartridge
is seated properly in the pocket.
NOTE: Only put a cartridge in
the machine and clamp it once.
Repeating clamping can break the seal
between the film and the cartridge.
A
B