mapleMaker Mini V2, Build Manual

Page: 137 / 138

F
6.1
137
Software Suite:
For detailed instructions on this procedure, please refer to the
guides and instructions on www.maplemakermedia.com. The
following is a brief overview of the procedure. Throughout the
next steps, we will be using the Arduino SDK, as well as the Cura
slicing engine and printer control.
The Arduino SDK can be downloaded from: http://www.arduino.
cc/en/Main/Software
Cura may be downloaded from: http://wiki.ultimaker.com/Cura
A Note on Self Sourcing Builders:
For those of who wish to source their own components outside
of the available kits, we want to clarify a few steps that must be
taken.
You will need to cut your linear rods to length, the lengths are as
follows. You will need to cut 2 of each:
X Axis: 250mm
Y Axis: 310mm
Z Axis: 250mm
Z Axis Threaded rod: 190mm
You will need to solder the wire connections to the limit switches.
These are wired in the normally open (NO) configuration. Refer to
the markings on the limit switch for the correct orientation. This is
typically the outer pins, with the centre third pin not being used.
Additional information is available through
www.maplemakermedia.com and www.reprap.org