Manufacture Corporation 94-1518PF, User Manual

Page: 77 / 280

68
5-4 PoE Auto Checking
This page allows the user to specify the auto detection parameters to check the linking status
between PoE ports and PDs. When it detected the fail connect, will reboot remote PD
automatically.
Web Interface
To configue Power over Ethernet Auto Checking in the web interface:
1. Click PoE Management and PoE Auto checking.
2. Enable the Ping Check function.
3. Specify the PD’s IP address, checking startup time, interval time, retry time, failure action
and reboot time.
4. Click Apply to apply the change.
Figure 5-4: The PoE Auto Checking
Parameter description:

Ping Check :
Enable Ping Check function can detects the connection between PoE port and power device.
Disable will turn off the detection.

Port :
This is the logical port number for this row.

Ping IP Address :
The PD's IP Address the system should ping.

Startup Time :
After startup time, device will enable auto checking. Default: 30, range: 30-60 sec.

Interval Time(sec) :
Device will send checking message to PD each interval time. Default: 30, range: 10-120 sec.

Retry Time :
When PoE port can't ping the PD, it will retry to send detection again. When the third time,