AVS A-SERIES INSTALLATION MANUAL - GEN 2 VER 5
11
Wiring instructions
Supply voltage:
12v DC
Current consumption:
Un-triggered: 29mA Armed, 25mA disarmed (MAX)
Location of main control unit:
Mounting of the alarm brain is central to a good alarm installation. Mount either behind centre console, behind
speedo cluster or left of dash. If this is not possible, mount under the driver’s side of the dash, but in an
inconspicuous location. Securely fix the unit with cable ties or similar ensuring the unit is solidly mounted and
cannot move around or be easily accessed. Failure to do this will result in poor shock sensitivity and glass
break function (if used). Start the install by mounting the brain in its intended location and then run the wires
out to their connection points looming the wires with the factory wiring wherever possible.
Plug connector (looking at alarm socket with wires facing):
If a tag is accidentally cut, or accessories are being added to the AVS A-Series alarm at a later date, it is possible
to trace the required wires by first un-clipping the case. Next, slide the circuit board out to expose the main
connector plug. Use the following connector diagram below to trace each wire and its function:
24
23
22
21
20
19
18
17
16
15
14
13
Unlock Unlock Lock Lock Lock BLKL IM1B IM1B IM1A IM1A DOOR GND
COM
NC
NO
COM
NC
Unlock BLKR
AUX
-LED HOOD BOOT -ARM 12V SIREN 12V GND IGN
NO
OUT
12
11
10
9
8
7
6
5
4
3
2
1
IMPORTANT: Even though the connector plug for the A-Series is similar to the ones used in the AVS
4601/6000/9000 models, THEY ARE NOT COMPATIBLE i.e. you can not plug an A-Series module into a harness
from the AVS 4601/6000/9000. Doing so will damage the unit and this will not be covered under warranty.
The AVS S-Series loom is compatible but has wires in pins 15, 16, 17 and 18 for immobiliser one.
MAP Upgrade Loom:
With the wires coming towards you from the socket and the lock tabs on top, the wiring is as follows.
From left to right, M1, M2, POS1, POS2, NEG1, NEG2
Plug-in Sensor Loom:
Black
–
Earth wire for sensors connected to
–
ARM wire
Red
–
Power wire for sensors connected to +12v wire
White
–
Trigger wire for sensors connected to AUX wire
IM3B
IM2A
IM2B
IM3A
