GROVE
3-49
TMS800E13 OPERATOR MANUAL
OPERATING CONTROLS AND PROCEDURES
3
Published 02-06-2014, Control # 495-00
5.
Continue to retract the stabilizers until they are fully
retracted.
6.
Position the desired Outrigger Selector switch to
EXTENSION and hold the Outrigger Extension/
Retraction switch to RETRACT. The appropriate
outrigger beam should begin to retract.
NOTE:
More than one outrigger beam may be retracted at
one time.
7.
After all outriggers have been fully retracted, stow the
outrigger floats. (Figure 3-22) Secure the floats with
quick pins and cotter pins.
Stowing the Mid-Extend Lock Pin
1.
Retract the outrigger extension/retraction cylinder.
NOTE:
If the lock pin (Figure 3-8) is wedged in the hole in
the outrigger beam, it may be necessary to jog the
outrigger extension/retraction switch slightly while
pulling upward on the pin.
2.
Lift the lock pin and turn it 90° to its stowed position.
FIGURE 3-22
6612
1
1
2
2
1
2
3
3
3
3
5
4
4
Item
Description
1
Cotter Pin
2
Quick Pin
3
Outrigger Float
4
Rubber Bumper
5
Frame
Locking Pin
FIGURE 3-23
4907-2
Reference Only
