Manitowoc Grove GMK 4100L-1, Operating Manual

Page: 344 / 1016

Driving modes
6.5 Installing/removing the outrigger beams
6 - 44 3 302 690 en Operating manual
GMK4100L-1
2
3
.1
1.
201
7
Inserting the
outrigger beam
•
Only insert the outrigger beam at the correct installation point. Note the
information on the label.
•
Remove the connecting elements from the connecting points ( 1 ) of the
supports.
•
Feed lifting gear ( 3 ) through the supporting
box and fasten it to the outrigger beam.
•
Sling the outrigger beam at the centre of
gravity (
2 );
à
Centre of gravity data
, p. 6 - 34.
•
Fasten two guide ropes ( 1 ).
•
Set the outrigger beam in the outrigger box.
•
Remove the guide rope ( 1 ).
G
Risk of being crushed by the swinging outrigger beam!
Do not guide the outrigger beam with your hands when inserting it.
Always used guide ropes and keep a suitable distance. This will prevent
limbs from being crushed between the supporting box and the outrigger
beam.
S
Risk of damage to hydraulic lines!
Ensure that the hydraulic lines on the outrigger beam do not remain hang-
ing on the supporting box and become damaged.
S
Risk of damage to the spacers!
Check that all spacers have been screwed in completely.
The prevents the spacers from remaining hanging in the supporting box
and becoming damaged.