Manitou M 26-2+H ST3B, Operator'S Manual

Page: 15 / 152

1 - 11
OPERATING THE LIFT TRUCK WITH A TRAILER
- For using a trailer, observe the regulations in force in your country (maximum travel speed, braking, maximum weight
of trailer, etc.).
- Do not forget to connect the trailer’s electrical equipment to that of the lift truck.
- The trailer's braking system must comply with current legislation.
- If pulling a trailer with assisted braking, the tractor lift truck must be equipped with a trailer braking mechanism. In this
case, do not forget to connect the trailer braking equipment to the lift truck.
- The vertical force on the towing hook must not exceed the maximum authorized by the manufacturer (consult the
manufacturer’s plate on your lift truck).
- The authorized gross vehicle weight must not exceed the maximum weight authorized by the manufacturer (consult
the manufacturer’s plate on your lift truck).
IF NECESSARY, CONSULT YOUR DEALER.
INSTRUCTIONS FOR HANDLING A LOAD
A - CHOICE OF ATTACHMENTS
- Only attachments approved by MANITOU can be used on its lift trucks.
- Make sure the attachment is appropriate for the work to be done (see: 4 - ADAPTABLE ATTACHMENTS IN OPTION ON
THE RANGE).
- Make sure the attachment is correctly installed and locked onto the lift truck carriage.
- Make sure that your lift truck attachments work properly.
- Comply with the load chart limits for the lift truck for the attachment used.
- Do not exceed the rated capacity of the attachment.
- Never lift a load in a sling without the attachment provided for the purpose. There are optional solutions; contact your
dealer.
B - MASS OF LOAD AND CENTRE OF GRAVITY
- Before taking up a load, you must know its mass and its center of gravity.
- The load chart for your lift truck is valid for a load in which the longitudinal position
of the center of gravity is 500mm or 600mm from the base of the forks (according
to the model of lift truck) (fig. B1). For a higher center of gravity, contact your dealer.
- For irregular loads, determine the transverse center of gravity before any movement
(fig. B2) and set it in the longitudinal axis of the lift truck.
t
IMPORTANT
t
It is forbidden to move a load heavier than the effective capacity defined on the lift truck load chart.
For loads with a moving center of gravity (e.g. liquids), take account of the variations in the center of gravity in order
to determine the load to be handled and be vigilant and take extra care to limit these variations as far as possible.
C - TRANSVERSE ATTITUDE OF THE LIFT TRUCK.
The transverse attitude is the transverse slope of the chassis with respect to the horizontal.
Raising the mast reduces the lift truck's lateral stability. The transverse attitude must be
set with the mast in down position as follows:
- Position the lift truck so that the bubble in the level is between the two lines (see: 2 - DESCRIPTION: INSTRUMENTS AND
CONTROLS).
500 mm
B1
B2
www. duma -rent.com