Mandik KFR-09GW/BP, User Manual

Page: 18 / 108

18
EN
How the air conditioner works
AUTO operation
„ „
When you set the air conditioner in AUTO mode, it will automatically select
cooling, heating(cooling/heating models only), or fan only operation de-
pending on set temperature and the room temperature
„ „ The air conditioner will control room temperature automatically to the tem-
perature point you set
„ „
If you feel uncomfortable in the AUTO mode, you can set your desired tem-
perature
SLEEp operation
When you push SLEEP button on remote controller during cooling, heat-
ing(cooling & heating models only), or AUTO operation, the air conditioner will
automatically increase (cooling) or decrease (heating) 1 oC / 2 oF per hour for
the first 2 hours, then hold steadily for the next 5 hours, after that it will switch
off This mode saves you energy and brings you comfort at night
DRYING operation
„ „
The fan speed will be automatically controlled under dry operation
„ „ During the dry operation, if the room temperature is lower than 10 oC
(50 oF), the compressor stops operation and restarts until the room temper-
ature is above 12 oC / 54 oF
Optimal operation
„ „ To achieve optimal performance, please note the following:
„ „
Adjust the air flow direction correctly so that it is not forwards people
„ „
Adjust the temperature to achieve the highest comfort level Do not adjust
the unit to excessive temperature levels
„ „ Close doors and windows on COOL or HEAT modes, or performance may
be reduced
„ „
Use TIMER ON button on the remote controller to select a time you want to
start your air conditioner
„ „ Do not put any object near air inlet or air outlet, as the efficiency of the
air conditioner may be reduced and the air conditioner may stop running
„ „
Clean the air filter periodically, otherwise cooling or heating performance
may be reduced
„ „ Do not operate unit with horizontal louvre in closed position
Care and Maintenance
Before mainatenance
„ „ Turn the system off before cleaning To clean, wipe with a soft, dry cloth Do
not use bleach or abrasives
NOTE: Power supply must be disconnectd before cleaning the indoor unit.
CAUTION
„ „ A cloth dampened with cold water may be used on the indoor unit if it is
very dirty Then wipe it with a dry cloth
„ „
Do not use a chemically treated cloth or duster to clean the unit
„ „
Do not use benzine, thinner, polishing powder, or similar solvents for clean-
ing These may cause the plastic surface to crack or deform
„ „
Never use water hotter than 40 oC/104 oF to clean the front panel
SLEEP operation
7 hours timer off
7 hours timer off
Set
Temperature
Set
Temperature
1 hour
1 hour
1 oC / 2 oF
1 oC / 2 oF
1 oC / 2 oF
1 oC / 2 oF
1 hour
1 hour
SLEEP operation
Filter Handle
Cooling
Heating
USER‘
S M
ANU
AL