Mandik KFR-09GW/BP, User Manual

Page: 17 / 108

17
EN
Manual operation
Units are equipped with a switch to run emergency operation mode It can be accessed by opening the front panel This switch is
used for manual operation in case the remote controller fails to work or maintenance necessary
NOTE: The unit must be turned off before operating the manual
control button. If the unit is operational, continue pressing the
manual control button until the unit is off.
1 Open and lift the front panel up to an angle until it remains
fixed with a clicking sound For some models, please use sus-
pension bars to prop up the panel
2 One press of the manual control switch will lead to the
forced AUTO operation If press the switch twice within five
seconds, the unit will operate under forced COOL operation
3 Close the panel firmly to its original position
CAUTION:
„ „
This switch is used for testing purposes only you had better
not choose it
„ „
To restore the remote controller operation, use the remote
controller directly
Airflow direction control
Adjust the air flow direction properly otherwise it might cause discomfort or cause uneven room temperatures
Adjust the horizontal louver using the remote controller
Adjust the vertical louver manually
To set the vertical air flow (Up-Down) direction Perform this
function while the unit is in operation Use the remote control-
ler to adjust the air flow direction The horizontal louver can be
moved at a range of 60 for each press, or swing up and down
automatically Please refer to the REMOTE CONTROLLER OPERA-
TION MANUAL for details
To set the horizontal air flow direction (left-right)
„ „ Move the deflector rod manually to adjust the air flow in the
direction you prefer
IMpORTANT: Do not put your fingers into the panel of blower
and suction side The high-speed fan inside may cause danger
CAUTION
„ „
Do not operate the air conditioner for long periods with the
air flow direction set downward in cooling or dehumidifying
mode Otherwise, condensation may occur on the surface
of the horizontal louver causing moisture to drop on to the
floor or on furnishings
„ „
When the air conditioner is started immediately after it was
stopped, the horizontal louver might not move for approxi-
mately 10 seconds
„ „
Open angle of the horizontal louver should not be set too
small, as COOLING or HEATING performance may be im-
paired due to too restricted air flow area
„ „ Do not move the horizontal louver manually, otherwise the
horizontal louver will be out of sync Please cease operating,
unplug power for a few seconds, then restart the air condi-
tioner
„ „ Do not operate unit with horizontal louver in closed position
AUTO/COOL
Manual switch
(1)
(2)
Manual switch
Range
Range
Deflector rod
Suspension
bars
AUTO/COOL
USER‘
S M
ANU
AL