Mandik KFR-09GW/BP, User Manual

Page: 21 / 108

21
EN
Troubleshooting guide
Trouble
OPERATION(RUN) indicator or other indicators
continue flashing
The unit may stop operation or continue to run in
a safety condition (depending on models) Waiting
for about 10 minutes, the fault may be recovered
automatically, if not, disconnect the power and then
connect it in again If the problem still exists, discon-
nect the power and contact the nearest customer
service center
If one of the following code appears on the display
area: E0, E1, E2, E3 , P0, P1, P2, P3 , or F0, F1, F2, F3
Fuse blows frequently or circuit breaker trips frequently
Stop the air conditioner immediately, disconnect the
power and contact the nearest customer service center
Other objects or water fall into the air conditioner
Terrible odors are smelled or abnormal sounds are
heard
Malfunctions Cause What should be done?
Unit does not start
Power cut Wait for power to be restored
Unit may have become Unplugged Check that plug is securely in wall receptacle
Fuse may have blown Replace the fuse
Battery in Remote controller may have been
exhausted
Replace the battery
The time you have set with timer is incorrect Wait or cancel timer setting
Unit not cooling or
heating (Cooling/
heating models only)
room very well while
air flowing out from
the air conditioner
Inappropriate temperature setting
Set temperature correctly For detailed method
please refer to “Using remote control” section
Air filter is blocked Clean the air filter
Doors or Windows are open Close the doors or windows
Air inlet or outlet of indoor or outdoor unit has
been blocked
Clear obstructions away first, then restart the unit
Compressor 3 minutes protection has been
activated
Wait
If the trouble has not been corrected, please contact a local dealer or the nearest customer service center Be sure to inform them
of the detailed malfunctions and unit model number
NOTE:
Do not attempt to repair the unit yourself. Always consult an authorized service provider.
USER‘
S M
ANU
AL