19
3.2
Getting the AED7000 Automatic External Defibrillator Ready
Carefully unpack and inspect all the AED7000 system components and accessories.
Install the battery. Verify that the self-test passes before putting the unit into
service. The device will perform an automatic self test upon being turned on.
3.2.1
Unpacking and Inspecting
Visually inspect the carton for any signs of damage or mishandling (carton
perforations, cuts, or dents; bent or collapsed corners; or broken carton seal).
Remove the AED7000 from the carton and inspect it carefully.
Before proceeding:
1. Open and carefully unpack each carton.
2. Examine the instruments and accessories for signs of
damage.
3. Check the packing list to determine that all accessories have
been received.
4. Contact M&B, Service Department at (+86)10-61253747 if
anything looks damaged or is missing.
3.2.2
Installing the Battery
The AED7000 uses an extended-life, Lithium non-rechargeable battery.
To install the battery:
1. Open the battery compartment (located near the bottom of
the backside of the AED7000) by removing the thumbscrews
and then sliding the battery cover up and off.
2. Locate the 3 battery contact pins in the bottom-right comer
of the battery compartment
3. Push the 3-pin battery connector onto the contact pins.
4. Place the battery into the battery compartment and replace
the battery cover.
5. Slide the cover back so that the screw holes are aligned.