Using Wireless Sensors is simple provided you are aware of the following facts:
1 - The operating range may vary widely from one installation and location to another. The position of the radio receiver
which is in the unit is therefore critical and must be chosen accordingly.
2- Each installation requires to learn two different I.D. Codes :
- a DETECTOR CODE for sensors and detectors and...
- a REMOTE CONTROL CODE for the hand held remote controls
- Each code has two parts:
IDENTIFICATION
and
FUNCTION
-
IDENTIFICATION :
This is the part that makes that device recognizable by the system.
-
FUNCTION :
This part is done on the unit. (see Programming mode adding detectors)
A 2 BUTTON REMOTE CONTROL IS USED: FOR PANIC ACTIVATION(BUTTON A) , FOR ARM/DISARM (BUTTON B)
WIRELESS DETECTORS AND REMOTE CONTROL OPERATION
To program the sensors and detectors see the instructions supplied with each device
IMPORTANT!!!:
- A wireless detector transmits an alarm condition only for a short period of time (2 - 4 Seconds)
- To save power the sensors are designed not to transmit if continuous movement is detected.
- A detector will only transmit if either a 30 seconds (test mode ) or 3 minutes (normal mode) has
elapsed from the last detection.
X00370 home_guard.CDR
-3-
