30
M5 – Eco
CE
The ball will emerge from the other end of the hose. Repeat the procedure
a sufficient number of times to eliminate all the dirt. After cleaning, empty
the hose carefully of any possible remaining water.
If the ball does not emerge, close the tap. Look for possible hard
parts to the touch from the opposite side of the tap. If they are
found, there is an incrustation that is preventing the emergence
of the ball. Hit the hose without damaging it until the hard part
softens. Open the water tap again and wait for the ball to
emerge. If the difficulty persists, repeat the procedure or, if
necessary, replace the hose.
Rinse with water to clean the pumping unit.
Procedure:
Fill the mixing chamber with clean water, start the
machine
„with the cell disc deactivated“
and pump
the water out of the machine.
Use a jet of water to clean the
sprayer and the nozzle. First remove
the nozzle from the sprayer and pre-
treat the tube with a pipe cleaner
(supplied).
It is possible to use a non-metallic
brush together with a jet of water In the case of
particularly resistant incrustations in the sprayer or the
nozzle.
In this way damage to the surfaces will not be possible
in any case.
Empty the container of material before cleaning the cell disc
and the container.
The machine must be stopped and disconnected from the
electrical power by removing the plug on the electrical box to
do this!
It is now possible to remove the protective grille
and take the dry material out.
It is first necessary to remove the cover and extract and remove the disc
from the central cone to clean the cell disc. The container and the disc
can be cleaned dry or with water. It is possible to use a non-metallic brush
in the case of persistent incrustations. This avoids damaging the cell disc.
Important
Important
ATTENTION
www.markham-sheffield.co.uk - Tel: +44 (0) 1909 730861
