Malossi 5518992, Manual

Page: 10 / 30

IT
ALIANO
ENGLISH
FRANÇ
AIS
10
of fuel under all conditions. The 8
fuel curves correspond to varying
levels of modifications.
When the key is turned to ON
for a few seconds, the display
will show the indication for the
selected map
(Fig. 12) .
Eight mapping (Table 1)
In addition to the 8 curves, there
are 3 potentiometers that allow
you to fine tune the curve you
select. These potentiometers
allow you to adjust the fuel curve
from +14% to –14% in 3 different
RPM ranges:
• low: 0 – 2,000 RPM
• mid: 2,000 – 6,000 RPM
• high: 6,000 – max RPM
To add fuel, turn the
potentiometers counterclockwise.
To subtrac fuel, turn the
potentiometer clockwise.
With the potentiometer pointed
straight up at the zero mark
(towards the Malossi logo), that is
0% adjustment.
With the potentiometer pointed
straight up at the “ - ” mark is
–14%.
With the potentiometer pointed
straight up at the “ + ” mark is
+14%.
Adjusting the potentiometer
between these points will result in
adding or subtracting an amount
of fuel proportional to how far the
knob was moved from zero.
Calibration
To select the right curve, start by
making sure that all 3 of the RPM
pots are set to zero adjustment.
Then select the base curve which
corresponds to the vehicle level
of modification.
This should make the vehicle run
better at all RPMs.
In case the configuration/
setting of your vehicle does
not correspond to any of those
indicated in the paragraph
“Working”, it is possible to
get a new tuning adjusting
the potentiometers as
above explained.
WARNING: do not attempt to
adjust while riding.