[3] DISASSEMBLY/ASSEMBLY
[3] -6. Impact Bolt Section (cont.)
DISASSEMBLING
ASSEMBLING
Fig. 40
Fig. 39
Fig. 40
Piston cylinder
as a repairing jig
Piston cylinder
as a repairing jig
Note: When assembling Ring spring 28 to Tool holder complete;
* Be careful not to position the Ring spring end in either of the side holes on Tool holder complete. (Fig. 30)
* Use an extra Piston cylinder as a jig. Never use the Piston cylinder built-in the machine.
Tool holder complete
Ring spring 28
Inner groove of
Tool holder complete
Ring spring 28
O ring case
(2) Push Ring spring 28 with Piston cylinder until it fits to the inner groove of Tool holder complete. (
Fig. 40
)
[3] -7. Swash Bearing Section
Stop ring E-4
Compression spring 5
Hex socket head bolt
M4x12 (2 pcs.)
Inner housing
Piston cylinder
Change plate
Fig. 42
Fig. 41
Piston
cylinder
Swash bearing
section
Piston cylinder
in the rear dead center position
Swash bearing section
Inner housing
Change plate
Change plate
Clutch cam
Remove Change plate from the groove of Clutch cam.
R
epair for 2 mode Rotary hammers HR2230, HR2460 and HR2460F
P 1
1
/
15
(1) Disassemble Chuck section.
Figs. 3 to Fig. 7
.
(2) Disassemble Change lever as drawn in
Figs. 9 and 10.
(3) Separate Gear housing complete from Motor housing. And then, remove Armature from Gear housing complete.
(
Figs. 17 to 20
)
(4) Remove Inner housing complete from Tool holder section. (
Figs. 21 and 22)
(5) Remove Stop ring E-4 and Compression spring 5 from the pin of Inner housing. (
Fig. 41
)
(6) Remove two M4x12 Hex socket head bolts that fasten Bearing retainer to Inner housing. (
Fig. 42
)
(7) Move Piston cylinder to the rear dead center position. (
Fig. 43
)
(8) Remove Swash bearing section from Inner housing by pulling in the direction of the arrow. (
Fig. 44
)
