15
1
2
3
011044
•
Chip receiver for hedge trimming (for Hedge Trimmer)
NOTE:
•
Some items in the list may be included in the tool
package as standard accessories. They may differ
from country to country.
Installing or removing hedge shear blades
CAUTION:
•
Before installing or removing shear blades, always
be sure that the tool is switched off and the battery
cartridge is removed.
•
When replacing the shear blades, always wear
gloves without removing blade cover so that hands
and face do not directly contact the blade. Failure
to do so may cause personal injury.
NOTE:
•
Do not wipe off grease from the gear and crank.
Failure to do so may cause damage to the tool.
•
For specific way of removing and installing shear
blades refer to the reverse of a package for
accessory shear blades.
Installing the hedge shear blades
Fig.28
Prepare the crank, the undercover and new shear blades.
1
2
010905
Adjust the three pin position so that these three pins are
aligned with the basic alignment line on the tool housing.
1
2
3
4
015776
Fit the crank with its recessed part facing downward
onto the pins. At this time, apply a small amount of
grease to the periphery of the crank using grease that
the shear blades as optional accessory are provided
with or that remains inside gear housing.
Fig.29
Overlap the oval hole in the upper blade with that in the
lower one. Move the shear blades so that the hole in the
base plate of shear blades are positioned in the center
of these overlapped oval holes.
Fig.30
Take out the blade cover from the old shear blades and
fit it onto the new ones for easy handling during the
replacement of blades.
Fig.31
Turn the shear blades upside down and install it so that
pin on the tool fit in the hole in the shear blades. Fit the
bent part of the base plate of the shear blades to the
groove in the tool housing. Then make sure that the
base plate of the shear blades is set in place.
1. Basic alignment line on the tool housing
2. Pins
1. Recessed part of crank
2. Crank
3. Apply grease
4. Pins
1. Hedge shear blade
2. Hedge shear blade cover
3. Storage case